Questions? Feedback? powered by Olark live chat software

Ground Problems

Posted by Portsmouth Trailer Supply on 22nd Mar 2024

When I have my headlights on and apply the brakes, all the lights on my trailer go out. What causes this?
You have a ground problem. In your situation, you have a ground that is strong enough to provide some lighting functions but not all. This is called a weak ground. When the taillights and brake lights are used at the same time, it creates the maximum amp load of lights on the trailer. If a ground problem exists, it will show at this point. The places to check grounds are as follows:

1. The connector on the vehicle should have a ground wire secured tightly to a clean surface on the frame. A wire attached to the body or a surface with undercoating or rust can cause a ground problem.

2. The connector on the trailer should have a wire from the connector secured tightly to a clean surface on the trailer.

3. Each tail lamp assembly at the back of the trailer also must be grounded. This is done in one of two ways. The first is by a separate wire coming from the back of each tail lamp assembly being secured to the frame. The second, and most popular, ground is achieved through the bolts of the tail lamp assembly. In this case, the lamp housing must be attached to the frame of the trailer. If the lights are mounted on wood or PVC material, the light will not receive ground.

4. The last possibility to explore is in the trailer design. If the trailer has a tilting bed, it is possible the ground is not passing through the pivot point resulting in a poor ground. The solution to this is to route a ground wire from the connector at the front of the trailer to each lamp assembly at the back of the trailer bypassing this pivot point.

NOTE: The trailer hitched to the ball of the vehicle should never be considered sufficient ground.

When I use one turn signal the other one blinks. What causes this?

This is usually related to one of two things. The first could be a short somewhere in the system. All wiring and the vehicle connector should be checked and tested. The second, which is the most common problem, is a weak ground in the system. Refer to the above question and follow steps one through four.

Provided by our vendor Hopkins Manufacturing Corporation